Jet-Stream "G" Gas Forced High Output Dryer

Heating chamber utilizes a preheat system with "bump" high energy quartz tubes. Large volumes of air, jet air knives and a high efficiency gas train provide the most efficient curing of evaporative inks and coatings
Solid state independent temperature controls to up to 350°F (177°C). Higher temperatures available
Air flow system removes solvents or water while creating a negative air force to hold stock down on the conveyor
Fresh air is delivered to the chamber in a steady, adjustable volume with up to 90% recycling
Adjustable direct fired burner combines gas and air to correct ratio for optimum flame. There is a separate source of air for combustion
Stock is held in place on the variable speed Fiberlon™ conveyor belt No fluttering
Re-circulating hoods on front and rear of dryer keep shop environment clean
Printed material is stabilized by the introduction of ambient air in the chamber
Easy to access and service
State-of-the-art safety system including restricted air flow alarm in case of clogged filters, super safe gas train system to ensure safe operation of gas, etc
Clean up easily with permanent stainless steel air filters
Adjustable inlet to drying chamber for different thicker substrates and for heat retention
Even heat distribution.
Digital speed belt readout
Double wall construction to keep heat in and outside surface cool to the touch
Modular expandable design
Meets and exceeds US and international safety requirements
Ambient temperature cooling chamber